|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manuale perfetto. Ottimo e utilissimo. Grazie a questo manuale ho potuto realmente risolvere il complesso problema della stampante.
 ;
Manuale perfetto. Ottimo e utilissimo. Grazie a questo manuale ho potuto realmente risolvere il complesso problema della stampante.
 ;
Was very fast and accurate service. Just what I needed. I recommend to everyone.
 ;
Very good scan quality, only PC Board scan not enough contrast.
 ;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
SA-AK330P / SA-AK330PC
10.12. Replacement for the pinch roller ass�y and head block
· Follow the (Step 1) - (Step 2) of Item 10.2 - Disassembly of Top Cabinet · Follow the (Step 1) - (Step 6) of Item 10.3 - Disassembly of CD Lid · Follow the (Step 1) of Item 10.4 - Disassembly of the Rear Panel · Follow the (Step 1) - (Step 3) of Item 10.5 - Disassembly of the CD Mechanism Unit · Follow the (Step 1) - (Step 3) of Item 10.9 - Disassembly of the Front Panel Unit · Follow the (Step 1) - (Step 5) of Item 10.10 - Disassembly of the Deck Mechanism Unit * The mechanism as shown below is for DECK1. For DECK 2, perform the same procedures. Step 1 Release the 2 claws, and then remove the pinch roller (R), (F). Step 2 Release ther 2 claws, and then remove the head connector.
Step 3 Remove 2 screws.
10.13. Replacement for the Deck motor ass�y, capstan belt A, capstan belt B and winding belt
· Follow the (Step 1) - (Step 2) of Item 10.2 - Disassembly of Top Cabinet · Follow the (Step 1) - (Step 6) of Item 10.3 - Disassembly of CD Lid · Follow the (Step 1) of Item 10.4 - Disassembly of the Rear Panel · Follow the (Step 1) - (Step 3) of Item 10.5 - Disassembly of the CD Mechanism Unit · Follow the (Step 1) - (Step 3) of Item 10.9 - Disassembly of the Front Panel Unit · Follow the (Step 1) - (Step 5) of Item 10.10 - Disassembly of the Deck Mechanism Unit Step 1 Release the 2 claws, and then remove the head connector. Step 2 De-solder plunger point. Step 3 Remove the Deck Mechanism P.C.B.
32
|
|
 |
> |
|