|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
 ;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
;
Welcome. The scheme is clearly helped me to repair. Worth to download it.
SA-HT640WP / SA-HT640WPC
Step 4 Remove the mechanism base block.
10.6. Disassembling the Rear Panel
· Follow (Step 1) to (Step 2) of Item 10.3. Step 1 Remove 7 screws. Step 2 Detach the FFC cable from connector (CN5704). Step 3 Release the claws of the rear panel in the directions. Step 4 Remove the rear panel in the direction of arrow.
10.8. Disassembling the FL & Head phone P.C.B.
· Follow (Step 1) to (Step 7) Item 10.4. Step 1 Remove 3 screws. Step 2 Remove the panel angle.
Step 3 Remove 7 screws.
10.7. Disassembling the Mechanism Base Assembly
· Follow (Step 1) to (Step 3) Item 10.5. Step 1 Remove 2 screws on each side of the mechanism base block. Caution: Take note of the screw type used. During assembling, use the correct screw type and at the correct location. Step 2 Remove the tab. Step 3 Detach FFC cables at connectors (CN2005 & CN2001).
Step 4 Remove the FL & Head phone P.C.B.
10.9. Disassembling the Main P.C.B.
· Follow (Step 1) to (Step 4) of Item 10.6. · Follow (Step 1) to (Step 4) of Item 10.7. Step 1 Remove 3 screws and 2 screw covers. Step 2 Detach the FFC cables from connectors (CN2011, CN5701, CN5708). Step 3 Remove the sheild plate. Step 4 Remove the Main P.C.B. 39
|
|
|
> |
|
