|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
;
thanks you are the best.Very good detail, Quick service response. A useful service manual with all details.
SA-PT960P / SA-PT960PC
Step 2 Screw the TR spring to the heatsink unit A. Step 3 Use a blower to remove the minute particles that might be caused after the process of the screwing TR spring to the heatsink unit A.
9.15. Replacement of Digital Amp IC (IC5200)
� Follow (Step 1) to (Step 3) of Item 9.3. � Follow (Step 1) to (Step 2) of Item 9.14. Step 1 Desolder pins of the digital amp IC (IC5200) on the reverse side of D-Amp P.C.B. Step 4 Solder pins of the digital amp IC (IC5000) on the reverse side of D-Amp P.C.B.
Step 2 Remove 1 screw. Special Note: Ensure pins of the digital amp IC (IC5000) are properly seated and soldered on D-Amp P.C.B. Step 5 Position the bottom chassis portion into the curves according to the diagram shown. (Rotate the part at 180 degrees as compared to its original position) Step 6 Screw the portion to the bottom chassis. Step 3 Remove the TR spring in the direction of arrows. Step 4 Remove the digital amp IC (IC5200) from the heatsink unit A. Caution: Handle the heatsink unit A with caution due to its high temperature after prolonged use. Touching it may lead to injuries.
55
|
|
|
> |
|
