|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
SA-WMSP75/WMSP85 SECTION 1 DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.)
Note on Printed Wiring Boards: � X : parts extracted from the component side. � Y : parts extracted from the conductor side. � b : Pattern from the side which enables seeing. Note on Schematic Diagram: � All capacitors are in µF unless otherwise noted. p: pF. 50 WV or less are not indicated except for electrolytics and tantalums. � 2 : nonflammable resistor. � 5 : fusible resistor. � All resistors are in � and 1/4 W or less unless otherwise specified. � C : panel designation.
The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. Les composants identifiés par une marque 0 sont critiques pour la sécurité. Ne les remplacer que par une pièce portant le numéro spécifié.
1-2. IC Block Diagrams
IC301 STK404-130S (MAIN Board)
� A : B+ Line. � B : B� Line. � Voltages are dc with respect to ground under no-signal conditions. no mark : Power on � Voltages are taken with a VOM (Input impedance 10M�). Voltage variations may be noted due to normal preduction tolerances. � Signal path. F : AUDIO � Abbreviation CND : Canadian model. E2 : 120V AC Area in E model. MX : Mexican model.
1
2
3
4
SUB
5
6
7
8
9
10
11
12
13
1-1. Circuit Board Location
INPUT(CONTROL) BOARD MAIN BOARD SWITCH BOARD
IC301 STK-404-100S (MAIN Board)
SUB 1 2 3 4 5 6 7 8 9 10 11 12
POWER TRANS BOARD
CONTROL BOARD
3
3
|
|
|
> |
|
