|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
;
I am proud of you. In the future, I benefited from your services.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
SA-WMSP87/WMSP87E SECTION 1 DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.)
Note on Printed Wiring Boards: � X : parts extracted from the component side. � Y : parts extracted from the conductor side. � : Pattern from the side which enables seeing. Note on Schematic Diagrams: � All capacitors are in µF unless otherwise noted. (p: pF) 50 WV or less are not indicated except for electrolytics and tantalums. � 2 : nonflammable resistor. � 5 : fusible resistor. � All resistors are in � and 1/4 W or less unless otherwise specified. � C : panel designation. Note: The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. Note: Les composants identifiés par une marque 0 sont critiques pour la sécurité. Ne les remplacer que par une piéce por tant le numéro spécifié.
MEMO
� A : B+ Line. � B : B� Line. � Voltages and dc with respect to ground under no-signal conditions. no mark : Power on � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Signal path. F : AUDIO � Abbreviation CND : Canadian model E51 : Chilean and Peruvian model
� Circuit Boards Location
(WMSP87E) (WMSP87) INPUT board SWITCH board (WMSP87E) SWITCH board (WMSP87) MAIN board
LED board (WMSP87E)
POWER TRANS board
CONTROL board (WMSP87E)
CONTROL board (WMSP87)
SA-WMSP87/WMSP87E
3
3
|
|
|
> |
|
