|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Everything fine: quick service, no glitch and above all a very good quality of the Pdf file. Thank you!
;
The manual was complete, parts list, adjustment procedures, etc. No worries
 ;
Very usefully, I could find the trouble clearly with that manual.
;
Bon produit. Permet de corriger les couleurs et de redonnez un petit coup de jeune à vos vieilles vidéos. On regrettera juste le manque d'une prise s-vidéo.
;
Quality scan of the actual service manual, just what I was looking for.
SA-WP16 SECTION 1 DIAGRAMS
� NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.) For schematic diagrams.
Note: � All capacitors are in µF unless otherwise noted. (p: pF) 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/4 W or less unless otherwise specified. � C : panel designation. Note: The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. � A : B+ Line. � B : B� Line. � Voltages and waveforms are dc with respect to ground under no-signal (detuned) conditions. no mark : Power on � : Impossible to measure � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Signal path. F : AUDIO � Abbreviation E51: Chilean and Peruvian model
Ver. 1.1
1-1. CIRCUIT BOARDS LOCATION
INPUT CONTROL board SWITCH board MAIN board
For printed wiring boards.
Note: � X : parts extracted from the component side. � a : Through hole. � : Pattern from the side which enables seeing. � Indication of transistor.
LED board
BEC These are omitted
BCE These are omitted
� Abbreviation E51: Chilean and Peruvian model
TRANS board
SA-WP16
3
3
|
|
|
> |
|
