|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Happy to find finally a schematic for this amplifier. The schematic is of good quality, the pcb layout is useless: all is black. Never the less, it is very easy to find the components on the board using the schematics.
;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
SA-WSLF10/SS-CTL10/TSL10/TSL11 SECTION 4 ELECTRICAL ADJUSTMENT
DIAT SIGNAL RF LEVEL ADJUSTMENT This adjustment is performed in order to adjust the transmission distance of RF signal for DIAT communication. Connection:
oscilloscope TX board TP815 (RF AMP OUT)
Procedure: 1. Connect the oscilloscope to TP815 (RF AMP OUT) and GND on the TX board. 2. Connect DIR-T1 to DIR-T1 jack (J908). 3. Adjust RV801 on the TX board so that the center of waveform becomes trigger level 1.05 Vp-p. (*Trigger position: �4 DIV) 4. Confirm trigger is locked. 5. Adjust RV801 on the TX board so that the center of waveform becomes 2.2 to 2.4 Vp-p.
VOLT/DIV : 500 mV TIME/DIV : 500 ns
level : 2.2 to 2.4 Vp-p
RF Signal Reference Waveform
Adjustment Location:
� TX BOARD (Component Side) �
RV801 DIAT Signal RF Level Adjustment IC804 IC805
TP815 (RF AMP OUT)
8
|
|
|
> |
|
