|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
You can adjust the output level while playing sources. You can adjust the level according to your preference by thickening or thinning the ultra bass, for example.
Press
Adjusting the subwoofer level
SUBWOOFER
to select a level.
� Select �--- � to stop output.
Adjustment range: --- (off), MIN (minimum), 5, 10, 15, 20, 25, MAX (maximum) Factory setting: SUBW 20
� Sound can be distorted if you raise the volume while the subwoofer level is high. Reduce the subwoofer level if this occurs. � Adjust the output level by taking steps described in �Testing speaker output/Adjusting speaker volumes� (á page 34) when you wish to make detailed settings.
Note
Press
Silencing speakers temporarily
MUTING � �MUTING IS ON � scrolls across the display while the volume is muted. � Press the button again to cancel the operation.
Muting is canceled when you turn the unit off or adjust the volume.
Note
Dimming the display light (Dimmer) n On the unit
Press
DIMMER � Press the button to dim the display. The light above [INPUT SELECTOR] and [VOLUME] goes off. � Press the button again to cancel the operation.
Note
Refer to page 37 for adjusting the brightness on the unit.
SPEAKERS
Press AUTO DETECTOR simultaneously to check the speaker presence.
Automatic speaker detection starts. 1) The unit checks the center speaker, surround
A
B
(e.g.) 1) 2) 3) 4)
speakers, surround back speakers and the subwoofer in that order. (The connection status for front speakers is always present.)
Detecting speaker status automatically
You can easily check connection status of each speaker when you want to. How speakers are displayed L : Front left C : Center R : Front right S : Surround SB : Surround back W : Subwoofer
2) The display shows the number of detected speakers (excluding the subwoofer). 3) The display shows connected speakers. 4) When automatic detection is finished, the display returns to the original.
Note
� Automatic detection does not work well depending on speakers and cables. Make speaker settings manually in such cases (á page 39). � These settings remain effective after the unit goes off. � To enjoy ELS Surround sound, be sure to perform the auto speaker setup (á pages 26 and 27) after this setting. � �WARNING � messages may appear on the display depending on detection results (á below). The right surround back speaker was detected, but the unit did not detect the left surround back speaker. Use the terminal for the left speaker when you connect one surround back speaker only (á page 23). The unit did not detect left and right surround speakers. Connect surround speakers as well when you connect surround back speakers to the unit. The unit did not detect one of the two surround speakers. Check speaker connections.
35
RQT8979
Operations Convenient functions
|
|
|
> |
|
