|
Who's Online
There currently are 5844 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I am a vintage hifi collector. No way to fix that device without the appropriate service manual...thanks to your site I got it and every thing is easier now. I got the manual right after ordering: fast cheap accurate ... thank you
;
Wonderful job clear. Qick fantastic. These people are really good. If even a problem arise they are wonderful assisting you. These scheme is so net despite this is a very old TV. Thank you for everything!!!!!!!!
;
Detailed schematic diagram, manual for professionals
;
Good service manual,exploded view,adjusment and test point locations,head alignment,mechanical checks and adjusments,all perfect.
;
Block diagram,play rec block diagram,adjusments, it's a very good well done repair manual.
KEX-M8886ZT ,M8886ZT-91
5. Details 1 Frequency characteristics adjustment function � The system changes submodes cyclically every time the [FM1/2] button is pressed when "AUDIO" is displayed. Set EQ Point 1 ¨ Set EQ Point 2 ¨ Set attenuation ¨ "AUDIO" � Set EQ Point 1 The system displays �P1� and EQ management number. The EQ management number ascends/descends every time the UP/DOWN button is pressed.The EQ management number consists of three digits (000 to 286). Initial value is 000 (no setting). � Set EQ Point 2 The system displays �P2� and EQ management number. The EQ management number ascends/descends every time the UP/DOWN button is pressed. The EQ management number consists of three digits (000 to 176). Initial value is 000 (no setting). � Set attenuation The system displays �L� and attenuation value. Use the UP/DOWN button to change attenuation within a range from 0 to -20 dB at increments of 1 dB. Attenuation value is shown in two digits from 00 to 20 (20 = -20 dB). Initial value is 00 (no setting). 2 level adjustment function � The system changes submodes cyclically every time the [TAPE] button is pressed when "AUDIO" is displayed. Set front ¨ Set rear ¨ Set woofer ¨ �AUDIO� � Set front The system displays "F" and level value.Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting). � Set rear The system displays "R" and level value. Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting).
� Set woofer The system displays "W" and level value. Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting). Notes: 1) Pressing the TAPE button during adjustment of frequency characteristics is invalid. Pressing the [FM1/2] button during level adjustment is invalid. 2) The UP/DOWN button mentioned above means the [SEEK] (UP,DOWN) key. Filter 1 : ATT of 30 to 35 dB for receiving frequency Filter 2 : ATT of 5 to 10 dB for receiving frequency The filter should not cause the switch to be set to OPEN when the filter is ON. If setting the switch to OPEN cannot be avoided, duration
43
|
|
|
> |
|