|
Who's Online
There currently are 5734 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
;
I liked the product. I would use their sevices again.
SECTION 2 DISASSEMBLY-1
Note: When the panel (loading) ass�y of this set is closed, you cannot confirm whether the disc and stabilizer ass�y are loaded inside or not. Accordingly, perform �Removal of Loading ass�y at Power ON/OFF� (see pages 12 and 13) to remove the disc and stabilizer ass�y, if loaded.
Note: Follow the disassembly procedure in the numerical order given.
U.S.A and Canadian Models only
REMOVAL OF LOADING ASS�Y AT POWER ON.
CAUTIONLaser radlation when open. DO NOT STARE INTO BEAM.
3-976-231-01
3 stabilizer ass�y
This caution label is located on the rear enclosure.
panel (loading) ass�y
4 disc
2 Press the eject button to open the panel (loading) ass�y.
1 Turn on the power .
5 four hexagon socket bolts (M4 � 8)
5 four hexagon socket bolts (M4 � 8)
8 loading ass�y section A
7 connector (CN503)
$
6 Place the front side of loading ass�y on the step at the rear side of front panel, and raise the rear side of loading ass�y in the direction A.
12
|
|
|
> |
|