|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
 ;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Other speaker setup options
� Attaching to a wall
1 Drive a screw (not included) into a wall. 2 Fit the speaker securely onto the screw(s) with the hole(s). �The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg (22 lb.) per screw. Consult a qualified building contractor when attaching the speakers to a wall. Improper attachment may result in damage to the wall and speakers. �7.5�9.4 mm (19/64q� 3/8q) 8�11 mm (3/8q� 7/16q) Wall or pillar 30�35 mm (13/16q�13/8q)
e.g.
Front speaker
Center speaker
110 mm (411/32q) So that the speaker fits up against the wall squarely, be sure to press the speaker cable down into the groove.
In this position, the speaker will likely fall if moved to the left or right.
Move the speaker so the screw is in this position.
� Fitting speaker stands (not included)
Ensure the stands meet these conditions before purchasing them. Observe the diameter and length of the screws and the distance between screws as shown in the diagram. �The stands must be able to support over 10 kg (22 lb.). �The stands must be stable even if the speakers are in a high position. e.g. Front speaker
5 mm (13/64z), pitch 0.8 mm (1/32z)
60 mm (223/64z)
Speaker stand (not included)
Attach the stands to these metal screw holes.
Plate thickness plus 7 to 10 mm (plus 9/32z to 25/64z)
RQT7433
5
Other speaker setup options
|
|
 |
> |
|