|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
DOLBY DIGITAL OR DTS (OR OTHER DIGITAL SURROUND MODE) CONNECTION
RECEIVER SUBWOOFER LINE LEVEL IN L LFE OUT LFE INPUT R
Use this installation method for Dolby Digital, DTS or other digital surround processors: Use the line-level input jack marked �LFE� for the Low-
Frequency Effects channel. Connect this jack to the LFE output or subwoofer output on your receiver or amplifier. Connect each speaker to the corresponding speaker terminals on your receiver or amplifier. Make sure that you have configured your surround sound processor for �Subwoofer On.� The
receiver should be configured for 6.1-channel operation (if available), and the front left, front right, center and rear speakers should all be set to �Small.� If your receiver allows you to set the crossover frequency between the subwoofer and the main speakers, select 120Hz or the setting that is the closest frequency below it.
DOLBY PRO LOGIC (NON-DIGITAL) � LINE LEVEL
Use this installation method for Dolby Pro Logic applications (not Dolby Digital, DTS or other digital processing), where the receiver/ processor is equipped with a subwoofer output, or a
volume-controlled preamp (line-) level output: Use RCA-type interconnects to connect the line-level subwoofer outputs on your receiver or amplifier to the line-level inputs on the subwoofer. IMPORTANT: Do not
+
�
+
�
+
�
use the LFE input on the subwoofer with Dolby Pro Logic processors. NOTE: If your receiver or amplifier only has one subwoofer output jack, then you will need to use a Y-connector (not included). Plug the male end of the Yconnector into your receiver or amplifier�s subwoofer output jack, and connect each of the two female ends to separate RCA-type interconnects. Finally, plug the RCAtype interconnects into the line-level inputs on the subwoofer. Connect each speaker to the corresponding speaker terminals on your receiver or amplifier. Make sure your receiver or processor is correctly configured to indicate that the subwoofer is �On.�
+
� + �
+
�
+
�
+
�
+
�
+
�
Note for advanced users: If your receiver/processor has a built-in low-pass crossover filter for the subwoofer output, you may use the LFE input to bypass the subwoofer�s internal crossover.
7
|
|
|
> |
|
