SHARP SD2060
Owner's Manual

I

INSERTS

1 4 7 0 / CLEAR
AUDIT

2 5 8

3 6
PROGRAM

5
P
CLEAR ALL

Enter the number of originals using the 10-key pad and then press the PROGRAM key. If the number of originals is not known, press only the PROGRAM key.
q

MAKING COPIES Inserts

If only the PROGRAM key is pressed, the number of originals will be counted. When counting is completed, replace the originals in the RADF tray. The message �PRINT ON THE CHAPTER PAGES? USE 10KEY PAD TO SELECT. YES: PUSH 1 appear. NO: PUSH 2� will

q

CA
2 5 8
AUDIT CLEAR

1 4 7 0/

3 6 9
CLEAR/STOP

6
<M092>

Press key 1 on the 10-key pad to select YES.
q

The following message will appear.

C/

PLEASE DESIGNATE ORIGINAL POSITIONS WHICH ARE TO BE CHAPTER PAGES. ENTRY SEQUENCE : 10-KEY / P KEY. TO END SEQUENCE : PRESS P KEY AGAIN. TO CORRECT SEQUENCE: PRESS a KEY. OUTPUT SAMPLE 1 2 4 5 7
3 6

PLEASE INPUT PAGE NUMBERS. P
q

I I

The P in the display corresponds to the position of the first original to be copied onto an insert sheet. In this example, this is position 3.

1 4 7 0 / CLEAR
AUDIT

2 5 8

3 6
PROGRAM

7
P
CLEAR ALL

Use the 10-key pad to designate the position of the first original to be copied onto an insert sheet and then press the PROGRAM key. In this example, press key 3 and then the PROGRAM key.
q

The entered number will be displayed on the bottom line of the message display.

CA

29