|
There are currently no product reviews.
 ;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
;
Dear Sir,
Document is original service document of sharp. I had a problem with the door contacts. Fuses where blown. With the manual in a few minuts is was clear what the problem was.
Manual was of great help.
With kind regards,
Martie Verhoeven
The Netherlands.
2. SYSTEM/KEY CIRCUIT (1) AUTO STOP
Auto Stop YES Does the SW25 waveform appear at the IC501 Pin105? YES Do the T-UP Reel Pulses appear at the IC501 Pin49? YES Replace the IC501. NO Do T/UP Reel Pulses appear at the Q514 Base terminal ? YES Replace the T/UP Reel Sensor (RS501). NO Does 5.2V appear at the RS501? YES NO NO Check the Drum Motor signal.
Check the Power Circuit.
(2) The unstable loading of a Cassette tape
The unstable loading of a Cassette tape YES Is 12V applied to the PMC01 Pin8? YES Does the �H� signal appear at the IC501 Pin30 during inserting the CST ? YES Does the �L� signal appear at the IC501 Pin72 during inserting the CST? NO YES Check the Deck Mechanism. Check the IC501 Pins68, 69, 70, 71. Check the CST SW and the peripheral circuitry. NO Is 5.3V applied to the R544 ? YES NO NO Check the Power.
Refer to SMPS 5.3VA troubleshooting.
Caution : Auto stop can occur because Grease or Oil is dried up
3-7
|
