|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
3. SERVO CIRCUIT (1) Unstable Video in PB MODE
Unstable Video in PB Mode. YES Does the Noise level of the screen change periodically? YES Do the CTL pulses appear at the IC501 Pin8? YES Does the CFG waveform appear at the IC501 Pin9? YES On tracking do the CTL pulses move? YES Does the Video Envelope waveform appear at the IC501 Pin24? YES Replace the IC501. NO Refer to �When the Y signal doesn�t appear on the screen in PB Mode�. NO Replace the IC501. NO Is adjusting the height of the CTL Head accurate? NO Readjust the height of the CTL Head.
Refer to �(2) No 12VA of Power section� Do the Drum PWM Pulses appear at the IC501 Pin107? YES Aren�t the foil patterns and the Components between IC501 Pin107 and PMC01 Pin12 short? NO Do the DFG Pulses appear at the IC501 Pin104? NO YES Do the Drum PWM Pulses appear at the IC501 Pin107? YES NO Replace the IC501. NO Aren�t the foil patterns and the Components between IC501 Pin104 and PMC01 Pin11 short? NO YES Do the DFG Pulses appear at the PMC01 Pin11? NO Replace the Cap M.
(2) When the Drum Motor (2) doesn�t run.
When the Drum Motor doesn�t run,
Does 12V appear at the PMC01 Pin8? YES Does 2.8V appear at the PMC01 Pin12? YES Check the connector (PMC01) and the Drum Motor Ass�y.
Aren�t the connecting patterns and the Components between IC501 Pin107 and PMC01 Pin12 short? 3-8
|
|
|
> |
|
