|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
 ;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
;
Excellent service manual with all the necessary info. :)
1-3-4. Sub Chassis (with a pickup mechanism) 1. Turn the mechanism chassis assembly (1) upside down. 2. Remove one screw (2) and release the boss �A� from the claw. Then remove the sub chassis (3) (with the pickup mechanism) by sliding in the arrow direction. 3. When mounting, perform the reverse order of the removal. Note: � When mounting the sub chassis (3) (with the pickup mechanism), first, insert the boss �C� along the groove of the cam slider up/down cam (4) and next, the boss �B� and �A�. � The boss �A� may be used with washers. (One or two washers are used to prevent from the slust rattling. In some cases, no washer is used.) When the washer(s) is used, be sure to assemble as it was without losing.
Sub chassis (3) (with the pickup mechanism attached) Boss C Screw (2) Boss A
1-3-5. Pickup Mechanism Assembly <Removal> 1. Remove four screws (1) and remove the pickup mechanism assembly (2). <Mounting> 1. Replace the pickup mechanism assembly (2) with a new one. 2. When mounting, perform the reverse order of the removal.
Damper (Blue) Damper (Green)
Damper (Blue)
Washer Boss B Cam slider up/down cam (4)
Damper (Green)
Pickup mechanism assembly (2)
Screws (1)
Fig. 2-1-14
Mechanism chassis assembly (1) Boss A
Note: � The dampers� color differs when used for the front side and the rear. � When mounting the pickup mechanism assembly (2) with the screws (1), push the pickup mechanism assembly (2) downward without being caught and tighten the screws (1).
Screw (1)
Boss B
Groove
Fig. 2-1-13
Pickup mechanism assembly (2) Damper
Fig. 2-1-15
|
|
|
> |
|
