|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
 ;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
;
The service was great and the document was also great. Highly recommend!!!!
If anyone has a users manual... Please email me. need one. $ [email protected]
2. SYSTEM/KEY CIRCUIT (1) AUTO STOP
Auto Stop YES Does the SW25 waveform appear at the IC501 Pin105? YES Do the T-UP Reel Pulses appear at the IC501 Pin49? YES Replace the IC501. NO Do T/UP Reel Pulses appear at the Q514 Base terminal ? YES Replace the T/UP Reel Sensor (RS501). NO Does 5.2V appear at the RS501? YES NO NO Check the Drum Motor signal.
Check the Power Circuit.
(2) The unstable loading of a Cassette tape
The unstable loading of a Cassette tape YES Is 12V applied to the PMC01 Pin8? YES Does the �H� signal appear at the IC501 Pin30 during inserting the CST ? YES Does the �L� signal appear at the IC501 Pin72 during inserting the CST? NO YES Check the Deck Mechanism. Check the IC501 Pins68, 69, 70, 71. Check the CST SW and the peripheral circuitry. NO Is 5.3V applied to the R544 ? YES NO NO Check the Power.
Refer to SMPS 5.3VA troubleshooting.
Caution : Auto stop can occur because Grease or Oil is dried up
3-7
|
|
|
> |
|
