|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
 ;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
Alignment and Adjustments
1-1-2 AM(MW),SW1,SW2 Adjustment
Circuit to be Adjusted Measuring Instrument & Step Arrangement S.S.G Radio dial Adjusting Frequency Setting Point Adjust for
1 OSC Connect AM signal generator to loop antenna,VTVM AND oscilloscope (Fig 1-3)
522KHz
522KHz
MW OSC
Adjust for (IR117)
1.0V±0.1V at the low.
2
1611KHz
1611KHz
MW OSC
Check for 7.0V±1.0V at the high.
(IR117)
AM (MW) RF � 1 594KHz 594KHz MW ANT Maximum out
INTER FREQ
�
1
455KHz
522KHz
TL2
Maximum out
OSC SW1 RF OSC SW2 RF
Fig 1-3
1 2 1 3.5MHz
2.3MHz 7.3MHz 3.5MHz 9.5MHz 26.1MHz 10MHz 10MHz
SW1 OSC SW1 ANT SW2 OSC SW2 ANT
Adjust for
1.0V±0.1V at the low.
Check for 8.5V±1.0V at the high.
Maximum out Adjust for
1.5V±0.1V at the low.
Fig 1-3
1 2 1
Check for 8.0V±1.0V at the high.
Maximum out
1-2
TOSHIBA
|
|
|
> |
|
