BEFORE USE
Inserting batteries into the remote control unit
1.
CAUTION Incorrect use of batteries may lead to leakage or rupture. Always be sure to follow these instructions. A. Never mix new and used batteries.
2.
Two DURACELL® 'AA' MN1500 1.5V ALKALINE dry cell batteries
B. Batteries of the same size may have different voltages depending on their type. Do not mix different types of batteries.
9 ( 9
(
Remote control operation range
Battery replacement
Replace the batteries when any of the following phenomena is observed. � The transmitting LED does not blink even when the TV POWER button is pressed. � The remote control operation range has reduced. When replacing the batteries, prepare new batteries before removing the old batteries.
30� 30� 23 feet (7m)
INTRODUCTION
Be sure to close the battery case cover after battery replacement.
NOTE: � Even when batteries are removed, learned commands remain in memory for about 15 minutes. � If you remove the batteries, and press a button, the memory is erased in a few seconds.
� Furniture and other obstacles may block the infrared light beam so that it cannot reach the sensor behind the Projection Monitor's screen. � Performance of the remote control unit is adversely affected by strong fluorescent light. Keep such lights away from the screen in particular.
11
<ARB1526>
