|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
;
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
4.7
CALIBRATION WALK-THROUGH
Quitting DACS4: � After a Complete Calibration When you have accepted the last channel, DACS4 will automatically transmit all settings to the SDEC and those settings will be burned to the nonvolatile FLASH memory. [F6]: Quits DACS4 Follow the instructions on the DACS4 screen to quit the program. Remove the �Loader� utility disk from the DACS4 computer and store it in a safe location at the installation site. All the usual admonitions about dust, heat and humidity apply to the choice of storage location. � Quitting When Some Channels Are Not Accepted If you must terminate a session before you have completed calibration, press [F6]. You will be warned that quitting before completion of the job will lose any settings you may have completed at this time. You will be given an opportunity to reverse your decision to quit. If you click [Cancel], you will be returned to the program. If you click [OK], all settings will be discarded and the program will be terminated. SDEC Maintenance: � Using The Loader Utility When you began the SDEC calibration process, DACS4 asked you to install the 3.5� floppy disk provided with the SDEC. After calibration is complete, this disk will contain a file that contains all settings made to the SDEC during calibration. Leave this disk at the installation site, using conventional precautions about dust, heat and humidity. In the event the SDEC needs to be replaced, you will use this disk to load the calibration settings into the replacement SDEC. To do this you will need a portable computer running Windows 3.xx or Windows 95. It must have an available COM port and a high-density disk drive. Use the following procedure to load the settings. 1. With everything off, connect a standard DB9 (9-pin) cable between the computer�s COM port and the connector located on the rear panel of the SDEC. 2. Turn on the SDEC. 3. Boot the computer to Windows. 4. Insert the disk. 5. Click on File, Run. 6. Type A:loader. 7. Press [Enter]. 8. Wait patiently. When the settings have been successfully transmitted and burned into the SDEC memory, a �DONE� dialog box will pop-up. 9. Turn everything off, remove the disk and return it to storage. Install the new SDEC.
54
|
|
|
> |
|
