|
There are currently no product reviews.
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
SD-NX10H
Check in the test mode � The spindle motor does not rotate.
Is waveform output from the pins 25 of IC1201 in the step 4 of AUTO auxiliary adjustment mode of TEST mode ? Yes Is waveform output from the pins 9 and 10 of IC1601 and the pins 4 and 5 of CN1401 ? Yes Replace with a spindle motor (complete). Check IC1601, CN1402, and soldering of mechanism switch PWB. No No Check the pins 25 of IC1201, soldering of peripheral circuit, and parts.
� The sled motor does not rotate.
Do the pins 23 of IC1201 change with the No Do the pins 14 and 15 of IC1601 and the pins 1 and 2 of CN1401 change with the / button ? Yes Does voltage of the + and - terminals on the sled motor change with the / button ? Yes Replace the sled motor. Check the soldering connected to the sled motor and for disconnection. No Check IC1601 and soldering of CN1401 / button ? Yes Check the waveform of pins 23 of IC1201, peripheral parts, and soldering.
No
� 85 �
|
