|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
 ;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
;
manual excelente completo , diagramas y esquemas bien presentados y buena calidad de imagen.
SH-HT441WP
Step 6 : Ensure that the Green LED (Digital Transmitter) is light-up. If it does not light up, there is no established link between them. (No communication is established between the digital transmitter & receiver unit). It could be due the below possible causes: 1. The digital transmitter unit is not fully inserted into the slot of the service jig. (Note: The wireless link indicator light will be flashing if the digital transmitter unit is not fully inserted into the slot. 2. The 5V DC power supply to the service jig is not connected properly or it is connected loosely. 3. The digital transmitter or the receiver unit is not operating properly due to power supply not connected properly. (Refer to section 9.3.1 for troubleshooting procedures for the receiver module P.C.B.) Step 7 : Ensure that the audio input into the digital transmitter can be heard from the speaker at the digital receiver unit. If there is no audio output at the speaker, check and confirm the connection of speakers at the rear of the receiver unit. (Refer to section 9.3.3 for the troubleshooting procedures for checking of power Amp IC).
32
|
|
|
> |
|
