|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent printing quality. A complete and very useful manual with all details.
;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
3.
TO REPLACE THE BATTERIES
1) Loosen the screw on the back of the unit that holds the battery compartment cover in place, and remove the cover. Loosen the screw that secures one of the two battery holders in place and remove the battery holder. Screw
2)
RESET
Caution: Be sure to remove only one battery at a time. Otherwise, you will lose all data stored in memory.
3)
Replace the old battery with a new one, making sure that the positive (+) side of the new battery is facing up (so you can see it).
4)
Replace the battery holder and secure it by tightening its screw. � Be sure careful that you do not over tighten the screw. Repeat steps 2) through 4) for the other two batteries. � Be sure to replace all two batteries. Never mix old batteries with new ones, and be sure to use CR2032 lithium batteries only. After you replace all two batteries, replace the battery compartment cover and secure it by tightening its screw. � Be careful that you do not over tighten the screw.
5)
6)
�5�
|
|
|
> |
|
