|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
3.1.3 G3 TRANSMISSION
The CIS picks up one line of image 1728 pels. The signal is then sent to the SDIP for digital processing. This processed data is paralleled out on the data bus and dumped into the T.4 to file buffer (MMR). After the data stored to T.4 to file buffer encodes, it is transfer to file to T.4 buffer (MR, MH, MMR) for transmission. The NS32FX200 generates a vector interrupt to the CPU to tell it to be ready for transmitting the image data. The NS32FX200 outputs the serial bit stream at sigma delta oversampling rate to the analog transmitter of the AFE. The serial bit stream is fed to a 7 bit D/A converter. This D/A converter is implemented by an analog switch, which selects either + 5V or -5V inputs. These voltages are filtered by an RC low pass filter to filter supply noise. The D/A output is filtered by three pole LPF with unit gain to attenuate the out-of-band quantization noise. The output of the LPF passes to the transformer through a 3 dB gain amplifier.
Transmission Block Diagram
3-3
|
|
|
> |
|
