|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
Place the new document stopper enclosed in the position from which the old document stopper was removed. Keep it pressed firmly against the document glass while securing it using the front and rear stopper mounting screws enclosed. Make sure that the tabs under the document stopper fit into the notches on the copier.
Tabs New document stopper Front stopper mounting screw Rear stopper mounting screw
Positioning the holes in the hinges of the ADF over the ADF mounting screws, secure the ADF with the 2 ADF securing screws.
ADF securing screw
ADF mounting screw
Notches
ADF securing screw
3. Mount the ADF onto the copier.
Remove the 2 cut-outs from the upper cabinet panel of the copier.
Cut-outs Upper rear cabinet panel
4. Adjust the angle of the ADF.
Loosen the 2 screws that secure the angle adjusting panel which fixes the hinge angle, then raise the angle adjusting panel completely and tighten the loosened screws.
Angle adjusting panel
Screws
Install the 2 ADF mounting screws.
ADF mounting screw ADF mounting screw
5. Connect the ADF connector.
Remove the connector cover from the rear cabinet panel of the copier. Plug the ADF connector into the connector on the copier.
ADF connector Connector cover
�3�
|
|
|
> |
|
