|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
S-FCRW230
7. ADJUSTMENT
ATTENTION
¶ Don� t make speaker terminal short circuit during the power supply injection. ¶ Since the PRIMARY part of the AMP ASSY is not insulated, be careful of electric shock. ¶ Be sure to disconnect the power supply cord before touching the AMP ASSY board. ¶ Discharge the C13, C14 capacitors!
7.1 MEASURING INSTRUMENTS
¶ Provide yourself with the following measuring devices: (1) Digital voltmeter (2) Oscilloscope (3) Attenuator (4) Low-frequency oscillator
7 GAIN Adjustment
(1) Decrease the level of the Adjustment Variable resistors (VR) for the channel to adjusted. (2) Increase LEVEL VOLUME maximum. (3) Adjust GAIN (VR41) volume. ¶ Apply the signal to the Line IN of JA201. ¶ As the gain from IN to SPEAKER OUT 53dB(freq. = 50 Hz), input of 10mVrms to Input results in output of 0.72 W (4.5 Vrms/28 W) at SPEAKER OUT. ¶ After power-supply ON, after waiting abut 10 seconds, it adjustment because, wave form rises behind time for slow start operation.
Test Point
A
Digital Voltmeter +
28� 3W
AMP ASSY
SIDE A
Adjustment VR VR41 Gain Adj
15
|
|
|
> |
|
