|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
e. When a staple jam occurs: Open the top cover, raise the stapler handle up and pull out the stapler. If the stapler is difficult to remove because of misfed paper, insert tool A in the maintenance pouch into the wheel of the stapler, then turn in either direction to ease stapler removal.
Raise the retaining lever and remove the staple caflridge from the stapler. Using tool B in the maintenance pouch, remove the retaining clip at the stapling position, remove the block at the tip, then remove the jammed staple.
/ Block Replace the block and the retaining clip to their original positions. Place the staple cartridge back into position. Lower the retaining lever to secure the staple mrtridge. Align the stapler with the groove and position it ifl PlaCe. Lower the st~ler handle back down as shown, Close the top cover. f. Make sure the copies are stapled.
Retaining clip
@ IPlace a set of copies on the top bin and make sure of the
(:orrect staple position. Press the manu~ staple key.
@ IRemove the copies from the top bin and check to be sure the
jtapler works properly. INote: If they are not stapled, repeat this procedure.
Copies ~qEW
Stapling position
-6-
|
|
|
> |
|
