|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
SF-S55 H. Adjusting the parallelism of bin unit aligning bar 1. Put A4 papers (about 10 sheets) into the upper limit and lower limit trays in contact with the reference bar. 2. Insert the screwdriver through the holes "a" and "b" of non-sort bin, and loosen the screws (2 pcs.). 3. Keep the aligning bar pressed against the adjusting plate with your fingers. 4. Insert the screwdriver through the hole "b" of non-sort bin, and tighten the screw. 5. Insert the screwdriver through the hole "b" of non-sort bin, and tighten the screw. 6. Pull the lower side of aligning bar, press it again against the adjusting plate, and make sure that the upper side and lower side contact at the same time. 7. Pull out paper. I. Adjusting the lead cam position 1) Remove the E-ring (2), and remove the flange (1) of lead cam shaft gear at the front side.
� �
� �
2)
Remove the belt (4) from the gear (3), and turn the lead cam (5) to align the position of front lead cam with the rear lead cam.
Aligning bar
A4 paper
5�5
 $4.99 SF-S55 SHARP
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
