|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was easy to order and received exactly what I needed. Only complaint would be the 24 hours you have to wait.
 ;
Manual was delivered in a timely manner and was all in English as advertised. The manuals I received when we moved into our flat were in German, Italian, and French. Having never used a steamer before, and not speaking/reading German very well, I needed an English Manual. this was a huge help.
;
Great Manual. This manual is available no where else. It was exactly what I was looking for. Only in German.
;
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
;
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
MAINTENANCE
Disassembling and reassembling the blade, pockets and teeth
IMPORTANT INFORMATION The cutters and pockets are mounted on the cutting wheel as illustrated. L = Left mounting R = Right mounting Ensure that the tooth cutters are turned in the cutting direction.
8011-215
WARNING! The cutters can come loose from the cutting wheel if the screws are not sufficiently tight. Comply with the recommended torque settings. Hold the teeth (30-31) in place as in the upper diagram when mounting the pockets (32-33). Risk for incorrect assembly. Insert the screw (34) in one pocket (32), through the blade section (28) and out though the pocket (33) on the other side. Make sure that the roll pins in the back edge of the teeth are seated against the back of the pockets. This provides the correct gauging of the cutter edge. Tighten the screws 162-203 Nm.
8011-216
Removing and refitting the wheels
To remove the left wheel (8) from the stump grinder, remove the locking collar (9), the 1/4" screws (10), the 1/4" hex nuts (3), the springs (4) and the brake pad (7). The wheel can now be removed from the axle. To remove the right wheel (2), remove the locking collar (1) and slide the wheel off the axle.
8011-217
32 � English
|
|
|
> |
|
