|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
RUNNING
5. 6. Hold in the the dead man�s grip bar and start the engine. Allow the engine to warm up for two minutes at idle before grinding.
8011-185 8011-127
7.
Tilt the machine on its wheels, lifting the cutting wheel off the ground/tree stump.
8011-202
8.
Set the throttle to ENGAGE.
8011-194
IMPORTANT INFORMATION If the cutting wheel is too low, the machine may start to �climb� over the stump and become instable. 9. Place the middle of the cutting wheel approximately 2.5 cm above and 2�4 cm into the stump.
8011-203
10. Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to side while lowering it about 2.5 cm after each pass until the front edge of the stump is gone. 24 � English
|
|
|
> |
|
