|
Who's Online
There currently are 6042 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
SH-FX60PP / SH-FX60TPP / SE-FX60PP
Step 2 : Detach the flat wire from the ribs of rear cabinet. (Ensure during assembly, the flat wire must be properly dressed in between the 2 supporting ribs.) Step 3 : Detach connector CN1003. Step 4 : Remove Receiver Module P.C.B. as arrow shown. Caution : Avoid applying excessive force. Use anti-static strap when removing the Receiver Module P.C.B. Step 1 : Remove Heat Sink Clip as arrow shown.
7.7.
Disassembly of Digital Amp P.C.B.
· Follow the (Step 1) - (Step 3) of item 7.4. · Follow the (Step 1) - (Step 2) of item 7.6.
Step 2 : De-solder digital Amp IC and remove Insulator IC. Note: During assembly, after replacement of new digital Amp IC installation of insulator needed.
7.9.
Disassembly of SMPS Module Unit
· Follow the (Step 1) - (Step 3) of item 7.4. Step 1 : Detach flat cabl (CN2). Step 2 : Remove Digital Amp P.C.B. as arrow shown. · Follow the (Step 1) - (Step 2) of item 7.6.
7.8.
Disassembly of Digital Amp IC
· Follow the (Step 1) - (Step 3) of item 7.4. · Follow the (Step 1) - (Step 2) of item 7.6. · Follow the (Step 1) - (Step 2) of item 7.7.
21
|
|
|
> |
|