|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
SH-FX67P / SE-FX67P / SH-FX67TPP
1.2.
Before Repair and Adjustment (Digital Receiver SE-FX67)
This model uses switching mode power supply (SMPS) module to provide the necessary voltages for the receiver (SE-FX67P) DO NOT SHORT-CIRCUIT DIRECTLY (with a screwdriver blade, for instance), as this may destroy solid state devices. After repairs are completed, restore power gradually using a variac, to avoid overcurrent. � Current consumption at AC 120 V, at 60 Hz in NO SIGNAL mode (at volume minimum) should be ~200 mA.
1.3.
Protection Circuitry
The protection circuitry may have operated if either of the following conditions are noticed: � No sound is heard when the power is turned on. � Stops during a performance. The function of this circuitry is to prevent circuitry damage if, for example, the positive and negative speaker connection wires are �shorted�, or if speaker systems with an impedance less than the indicated rated impedance of the amplifier are used. If this occurs, follow the procedure outlines below: 1. Turn off the power. 2. Determine the cause of the problem and correct it. 3. Turn on the power once again after one minute. Note: When the protection circuitry functions, the unit will not operate unless the power is first turned off and then on again.
1.4.
Safety Part Information
Safety Parts List: There are special components used in this equipment which are important for safety.These parts are marked by in the Schematic Diagrams & Replacement Parts List. It is essential that these critical partsshould be replaced with manufacturer�s specified parts to prevent shock, fire or other hazards. Do not modify the original designwithout permission of manufacturer.
Table 1 Reference No. A1 18 F1 Part No. K2CB2CB00021 N0AB6GY00005 RFKHFX67P-K Part Name & Description AC CORD SMPS PCB FUSE Remarks [M] [M] (RTL) [M]
4
|
|
|
> |
|
