|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality, prompt response. This website has reasonable prices and wide range of manuals that are hard to find.
;
The document was usefull, and it was exactly what I was looking for.
;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
ORDER NO.
Front Center Rear
RRV2359
S-HS77-F
S-HS77-CR
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
[ Front speaker ] The grille is attached to the cabinet by catches. Detach by pulling it toward you. The woofer is attached to the baffle by 4 external screws. To detach it, unfasten those screws. When attaching it, face its terminal downward. The midrange is attached to the flange lower side by 4 external screws. To detach it, unfasten those screws. When attaching it, face its terminal downward. The tweeter is attached to the flange upper side by 2 external screws. To detach it, unfasten those screws. When attaching it, first reattach the packing around tweeter diaphragm, then face its terminal downward. The flange is attached to the baffle by 4 external screws. To detach it, unfasten those screws. When attaching it, face it downward. To detach the midrange or tweeter, first remove the flange. Then remove it. The input terminal is attached to the back board by press-fitting and applied with adhesive. To detach it, pry it open by inserting a flat blade screwdriver into lower side. The Network Assy is attached to the input terminal by soldaring.
SPEAKER SYSTEM
XMA/NC
XMA/NC
[ Center speaker ] The grille is attached to the cabinet by catches. Detach by pulling it toward you. The woofer is attached to the baffle by 4 external screws. To detach it, unfasten those screws. When attaching it, first exchange the flange, then face its terminal downward. The tweeter is attached to the baffle by 4 external screws. The cosmetic packing is attached to the flange applied with adhesive.To detach the tweeter. First remove the cosmetic packing, then unfasten those screws. When attach it, do so that it will move vertical. The tweeter wires, connected in the middle of network Assy , are covered with the insulating tape. The input terminal is attached to the back board by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side. The Network Assy is attached to the input terminal by soldaring.
[ Rear speaker ] When exchange the rear speaker, do it with the CS Assy (R).
PIONEER CORPORATION
4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2000
T-ZZM JULY 2000 Printed in Japan
|
|
|
> |
|
