|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
A
� The grille is inserted into the baf�e. To detach it, insert a grill removal tool into each of the 4 corner holes of the grille net and pull it out carefully. � The subframe is attached to the baf�e frame by 4 external screws. To detach it, unfasten those screws. (for IW631 and IW651) � The crossover networks is attached to the baf�e frame by 4 external screws. To detach them, �rst disconnect the speaker's wires. Next remove the baf�e frame. Then unfasten those screws.
B
� The tweeter is attached to the baf�e by 2 external screws. To detach it, unfasten those screws. When re-attaching it, face its terminal rightward. [S-IW631-LR, S-IW831-LR only] � The woofer is attached to the baf�e by 4 external screws. To detach it, unfasten those screws. When re-attaching it, face its terminal lower right. � Attach the speaker frame to the wall /ceiling, and tighten the screws lightly (temporary attachment). At this point the rotating clamp will rotate so that the rotating clamp and frame are clamped on to the wall/ceiling. Gently try pulling the speaker forward and check that all of the rotating clamps have rotated outwards and are lightly clamping to the wall/ceiling. Speaker frame Screw
C
Rotating clamp
D
� Tighten the screws �rmly using no more than the maximum torque speci�ed. Allowable maximum torque: 1.0 N.m
E
F
2
1 2
S-IW631-LR
3 4
|
|
|
> |
|
