|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great quality copy, right what I was looking for, all I need to fix my radio.
Thanks
;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
SJ-P43N/43N SJ-P47N/47N
(2)-4. Replace Def. heater ass'y with new one.
Heater cover
(2)-7. Stick the longer wire to the Drain support by aluminum tape (2 pieces), and wind vinyl tape (2 pieces) to lead wires of Def. heater ass'y by aluminum tape as shown in Fig. A-25. Note: Glass cloth tape part shall be both side of Drain support to protect the lead wire from damaged.
Glass cloth tape
Def.heater ass�y
Glass cloth tape
A
Sec. AA
A
[back side]
aluminum tape
(W25 X L40)
Drain support al
Fig. A-22
Glass cloth tape
Glass cloth tape
(more than 2 turns)
(2)-5. Wind the Glass cloth tape (3M: No. 27) to lead wire of Def. heater ass'y. (2 places)
Def. heater ass�y
360 + 5 (40) 50 + 5 (40)
[bottom side]
Fig. A-25 (2)-8. Set Heater cover on Drain support, and bend top edge c and d to outside as shown in Fig. A-26.
Heater cover
Glass cloth tape (W40 x L25)
top edge
Drain support al Heater cover
Def.heater ass�y
Lead wire Glass cloth tape Wind the Glass cloth tape more than 2 turns.
c
Sec. BB
Fig. A-23 (2)-6. Bend a and b of Drain support al to right angle (90�) to set Def. heater ass'y. (Fig. A-24)
This side is longer wire
B
d
Def.heater ass�y
B
Fig. A-26 (2)-9. Wind up Leading wire sealer as shown in Fig. A-27
a
This side is shorter wire
Drain support al Heater cover Leading wire sealer
Drain support al
90 1
+ 20
Def.heater ass�y
b
Def.heater ass�y
Fig. A-24 Fig. A-27 (2)-10. Set the assembly above on the food liner by fixing a screw.
24
|
|
|
> |
|
