SHARP SJ-P47N-WH2
Service Manual

SJ-P43N/43N SJ-P47N/47N

(2)-4. Replace Def. heater ass'y with new one.

Heater cover

(2)-7. Stick the longer wire to the Drain support by aluminum tape (2 pieces), and wind vinyl tape (2 pieces) to lead wires of Def. heater ass'y by aluminum tape as shown in Fig. A-25. Note: Glass cloth tape part shall be both side of Drain support to protect the lead wire from damaged.
Glass cloth tape

Def.heater ass�y

Glass cloth tape

A

Sec. AA

A

[back side]

aluminum tape
(W25 X L40)

Drain support al

Fig. A-22
Glass cloth tape

Glass cloth tape
(more than 2 turns)

(2)-5. Wind the Glass cloth tape (3M: No. 27) to lead wire of Def. heater ass'y. (2 places)
Def. heater ass�y
360 + 5 (40) 50 + 5 (40)

[bottom side]

Fig. A-25 (2)-8. Set Heater cover on Drain support, and bend top edge c and d to outside as shown in Fig. A-26.
Heater cover
Glass cloth tape (W40 x L25)
top edge

Drain support al Heater cover

Def.heater ass�y

Lead wire Glass cloth tape Wind the Glass cloth tape more than 2 turns.
c

Sec. BB

Fig. A-23 (2)-6. Bend a and b of Drain support al to right angle (90�) to set Def. heater ass'y. (Fig. A-24)
This side is longer wire

B

d

Def.heater ass�y
B

Fig. A-26 (2)-9. Wind up Leading wire sealer as shown in Fig. A-27

a

This side is shorter wire

Drain support al Heater cover Leading wire sealer

Drain support al
90 1

+ 20

Def.heater ass�y

b
Def.heater ass�y

Fig. A-24 Fig. A-27 (2)-10. Set the assembly above on the food liner by fixing a screw.
24