|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
 ;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
 ;
Super nice! Good to have a manual in digital format.
 ;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
SL-107_Chi.book Page 7 Tuesday, September 30, 2003 2:43 PM
Subwoofer effects
Adding a subwoofer to your speaker system expands the bandwidth of the bass range. However, if the subwoofer�s reproduction bandwidth or sound output level is improperly adjusted, the overall performance may decrease, as shown in the graphs below. When the subwoofer�s reproduction bandwidth is correct
Overall characteristics
Adjustments
Crossover frequency and output level � Adjust the SL-107 output level and crossover frequency to suit your listening room and connected speakers. � When the unit is connected to an ampli�er via the SPEAKER LEVEL INPUT terminals, setting the OUTPUT LEVEL knob near the center position will create a well-balanced sound level on most speakers. � Be aware that you might set the subwoofer to a high output level because superbass-range sound is less audible than other sound ranges. To obtain well-balanced frequency characteristics, set the output level to a slightly lower level than seems optimal. (This will also prevent the input of signals that are too strong.) Note: Be careful not to allow the input of excessive power. Input levels that greatly exceed normal situations can damage the SL-107. Also note that switching operations at the ampli�er may generate excessive noise that may result in damage. When using switches at the ampli�er, �rst lower the volume to prevent accidental damage.
Speaker characteristics
Subwoofer characteristics
When the subwoofer�s output level is incorrect
Output level is too high
Output level is too low
Placement
The placement of the SL-107 can greatly affect the sound that is produced. In general, a good bass sound can be obtained by installing the subwoofer in a front corner, or at one-third the width of the wall, as shown.
When the subwoofer�s reproduction bandwidth is far from the speaker�s bandwidth
Curve is sunken
When the subwoofer�s reproduction bandwidth is close to the speaker�s bandwidth
Curve is raised
En-7
|
|
 |
> |
|