|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
 ;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
Trouble Diagnosis
8-2. Typical Symptoms of PCBs problem or bad connection A. Symptom of initial latch up - Define initial latch up : When turn on the power, both LEDs light up red and TV is not working. - Repairing method : This is typical symptom when ROM(ICU3) is incorrectly connected at socket. So if you find this symptom, you must try to that ROM(ICU3) and socket have correct contact. - As this method, TV set is not repaired, replace MAIN PCB. B. Symptom of No image when LED and Back Light are working. - Define No image : LED and BACK LIGHT of panel are correctly working but any image does not display. - Repairing method : This is typical symptom when LVDS cable incorrectly connects. So if you find this symptom, check LVDS connection. - As this method, TV set is not repaired, replace Main or Sub PCB. C. Representative Symptom caused by bad Connection between PCBs => Note: Dust or extraneous material may cause bad connections. Most of the time, applying soft brush, AIR FRESHIER, or breath to clean dust or extraneous materials can solve it. And then reassemble the Connector.
-44-
|
|
|
> |
|
|
Parse Time: 0.204 - Number of Queries: 133 - Query Time: 0.041
