|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
PC-UM10M
8. SHORT BATTERY LIFE
First of all, explain that the battery life varies depending on the use environment and the operating conditions. 1) According to �BATTERY VOLTAGE ADJUSTMENT PROCEDURE� on the Service Manual, check the set values. (If necessary, make setting again. 2) Execute �CURRENT COMSUMPTION CHECK� on the Service Manual to check the current value. 3) Replace the battery pack.
9. THE CF CARD (SD CARD) IS NOT RECOGNIZED. / WHEN THE CF CARD IS INSERTED, NO OPERATION IS PERFORMED
First of all, check for deformation of the connector terminal of each card. 1) Check CF CD and SD CD on the right lower side of the diag menu. All should be "H." 2) Insert the CF card and the SD card, and check again. All should be "L."
NG(Remains at "H")
The card is not recognized. When the CF card : Check "CD" pin of the connector and is not recognized check CCD** of BR403 and IC401. When the SD card : Check soldering of the terminals outside is not recognized of the connector of CN1002 of the sub PWB. Check IC901 and BR906. TOP This terminal
3) When the CF card is inserted, no operation is performed.
Check with the OS. When the "WAIT" signal of the card is at "LOW", no operation is performed. (Wait is applied to the operation.) Check IC401 and BR402. (Check that soldering is properly made and that the resistors are not broken.)
SL-5500 TROUBLE SHOOTING
� 62 �
|
|
|
> |
|
