|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
ORDER NO.
RRV2030
SPEAKER SYSTEM
S-L7-K-LRW
This product is component of system. For the operating instructions, refer to the service manual RRV1946 for XC-L7. S-L7-K-LRW/XE consists of Satellite Speaker(2pcs) and Subwoofer(1pc). FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
[ Satellite Speaker ] The grille is attached to the cabinet by 4 external screws. To detach it, unfasten those screws. The speaker element, together with the grille is attached to the cabinet by 2 external screws. To detach it, unfasten those screws. When attaching it, face its terminal upper left. The cabinet is attached to the baffle by 4 external screws. To detach it, first remove the grille. Then remove the cabinet. The input terminal is attached to the cabinet by 2 internal screws. To detach it, first remove the grille and the baffle. Then remove the input terminal. The bushing is attached to the cabinet by press-fitting. To detach it, first remove the grille. Then remove the bushing.
XE
[ Subwoofer ] The speaker element, together with the flange, is attached to the back board by 4 external screws. To detach it, unfasten those screws. When attaching it, face its terminal upward. The duct is attached to the baffle by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side. The input terminal is attached to the back board by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side.
PIONEER ELECTRONIC CORPORATION
4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER ELECTRONIC (EUROPE) N.V. Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 501 Orchard Road, #10-00 Wheelock Place, Singapore 238880
PIONEER ELECTRONIC CORPORATION 1998
T-ZZW OCT. 1998 Printed in Japan
|
|
|
> |
|
