|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
EN
Changing Settings for a Non-Active Network Profile
By default, any changes you make to network settings will be applied to the active profile (i.e. the profile that is currently loaded on the SLA5500). If you wish to make changes to a different profile, you must first turn on profile management. 1 Press SYSTEM (6) on the remote control to display the Configuration menu. 2 Press 4 until �Advanced Settings� is highlighted. Press 2. 3 When �Profile Management [ ]� is highlighted, press 2. 4 When �Enabled� is highlighted. Press 2 to activate the setting [*]. 5 Now follow the steps under �Changing Network Settings� to change the network profile settings. You will be prompted to select the profile to be changed. Note: If you want to make this profile the active profile for the SLA5500 follow the steps under �Activating a New Profile on the SLA5500 Using Remote Control�.
Turning Profile Management Off
When you have made changes to non-active profiles, you can turn off Profile Management, as follows: 1 Press SYSTEM (6) on the remote control to display the Configuration menu. 2 Press 4 until �Advanced Settings� is highlighted. Press 2. 3 When �Profile Management [ ]� is highlighted, press 2. 4 Press 4 until �Disabled� is highlighted. Press 2 to de-activate the setting [*].
Managing Multiple Key Indexes
The SLA5500 supports up to 4 Key Indexes for WEP encryption. By default, Key Index 1 is used when a WEP Key is entered. However, if you wish to enter a key against another Key Index, follow these steps: 1 Press SYSTEM (6) on the remote control to display the Configuration menu. 2 Press 4 until �Advanced Settings� is highlighted. Press 2. 3 When �Key Management [ ]� is highlighted, press 2. 4 When �Enabled� is highlighted. Press 2 to activate the setting [*]. 5 Press 2 to complete the change. 6 Now follow the steps under �Changing Network Settings� to change the network profile settings. You will be prompted to select a �Key Index� before entering the WEP key. 7 Ensure that you select �Exit Key Editing� when you have finished, and turn off �Key Management� under �Advanced Settings� when finished.
29
|
|
|
> |
|
