|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
bye
 ;
This service manual is a good copy of the original, complete and fully readable. It is really useful to repair my Tv set following its clear instructions.
;
Excellent quality. Easy process to download. No issues or problems at all - was exactly what I was looking for and needed. Great service.
;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
SLV-ED10/ED40/ED60/ED70/EZ10/EZ40/EZ60/EZ70 SECTION 4 PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary mote is printed in each block.)
For printed wiring board: � X : indicates a lead wire mounted on the component side. � x : indicates a lead wire mounted on the printed side. � ® : Through hole. � p : Parts mounted on the conductor side. � b : Pattern from the side which enables seeing. (The other layers� patterns are not indicated.) Caution: Pattern face side: (Side B) Parts face side: (Side A) Parts on the pattern face side seen from the pattern face are indicated. Parts on the parts face side seen from the parts face are indicated. For schematic Diagram: � Caution when replacing chip parts. New parts must be attached after removal of chip. Be careful not to heat the minus side of tantalum capacitor, because it is damaged by the heat. � All resistors are in ohms, 1/4 W (Chip resistors : 1/10 W) unless otherwise specified. k� : 1000�, MW : 1000k�. � All capacitors are in µF unless otherwise noted. pF : µµF 50V or less are not indicated except for electrolytics and tantalums. � � � � � � � � � � � � � All variable and adjustable resistors have characteristic curve B, unless otherwise noted. 2 : nonflammable resistor. 5 : fusible resistor. C : panel designation. ¢ : internal component. C : adjustment for repair. U : B+ Line. V : B� Line. Circled numbers refer to waveforms. Voltages are dc between measurement point. Readings are taken with a color-bar signal input. Readings are taken with a digital multimeter (DC 10MW). Voltage variations may be noted due to normal production tolerances. Note: The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specified. When indicating parts by reference number, please include the board name.
4-1
|
|
|
> |
|
