|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm quite impressed. I had to wait 24 hours for my manual (quite a rare one) but I got it and the quality was good. Also, from trawling the web, these prices are by far the best.
;
Manuale perfetto. Ottimo e utilissimo. Grazie a questo manuale ho potuto realmente risolvere il complesso problema della stampante.
;
Manuale perfetto. Ottimo e utilissimo. Grazie a questo manuale ho potuto realmente risolvere il complesso problema della stampante.
 ;
Was very fast and accurate service. Just what I needed. I recommend to everyone.
;
Very good scan quality, only PC Board scan not enough contrast.
IMPORTANT SERVICE GUIDE
� MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT
1) When installing the ass�y deck on the Main PCB, be sure to align the assembly point of mode switch.
ASSEMBLY POINT (ALIGN TWO ARROWS)
Fig. 1
� HOW TO EJECT THE CASSETTE TAPE (If the unit does not operate on condition that tape is inserted into housing ass�y)
1) Turn the Gear Worm 1 clockwise in the direction of arrow with screw driver. (See Fig. 2) (Other method ; Remove the screw of Motor Load Ass�y, Separate the Motor Load Ass�y) 2) When Slider S, T are approached in the position of unloading, rotate holder Clutch counterclockwise after inserting screw driver in the hole of frame�s bottom in order to wind the unwiunded tape. (Refer to Fig. 3) (If you rotate Gear Worm 1 continuously when tape is in state of unwinding, you may cause a tape contamination by grease and tape damage. Be sure to wind the unwiunded tape in the state of set horizontally.) 3) Rotate Gear Worm 1 clockwise using screw driver again up to the state of eject mode and then pick out the tape. (Refer to Fig. 2)
1 GEAR WORM
FRAME
Fig. 2
Fig. 3
�4�
|
|
|
> |
|
