|
There are currently no product reviews.
 ;
So usefull to make my installation a breeze. 5 stars on quality.
;
very helpful, the information in these manuels are very detailed
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Good copy and great customer service! There was some confusion with my order and it was resolved promptly!
Step 4
Tuning your TV to the VCR
If you have connected your VCR to the TV using the EURO-AV cable, skip this step. Make sure to match the COMMAND MODE of the VCR and the remote commander. This VCR and remote commander are set to VTR3 at the factory.
ON/STANDBY PROGRAM +/�
COMMAND RF-CH MODE
1 2
ON/STANDBY
Press ON/STANDBY to turn on the VCR.
Press RF-CH on the VCR.
RF-CH
The factory-preset RF channel appears in the display window. The VCR signal is output through this channel to the TV.
RF
3 4
Turn on your TV and select a programme position for the VCR picture. This channel will now be referred to as the video channel. Tune the TV to the same channel as that shown in the display window so that the picture on the right appears on the TV screen. Refer to your TV manual for tuning instructions. If the picture does not appear clearly, see �To obtain a clear picture from the VCR� on the next page.
12
Getting Started
|
