|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A complete manual with all the needed details of calibrations and service instructions about the radio receiver.
A big deal.
Many thanks !
;
Fast delivery and good quality copy. To be recommended
;
Excellent product, very clear print. Detailed circuit and assembly diagrams - this enabled me to repair my CD player with confidence. I highly recommend this site.
;
Fast access, 100% correct and complete service manual
;
just what i was seeking .had a password issue but the review allowed me to circumvent and download was great
S-LX70-LR
SPEAKER SYSTEM
Even though the suffix is different between /XDCN5 and /SXTW/EW5, both models are completely same product.
1.1 GRILLE
� The grille is attached to the cabinet with catches and adhesive. To remove the grille, use a thin, rigid object, such as a flat blade screwdriver or metal ruler, to pry it off, being careful not to damage its acrylic coating. To reattach the grille, apply adhesive to the catches and then press the grille firmly to the cabinet.
S-LX70-LR
XDCN5
PRT149
ORDER NO.
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
4. Remove the 4 screws from the tweeter, then pull the tweeter out through the hole for the woofer. To reinstall the tweeter, place it so that its terminal plate faces to the upper. Reattach the tweeter so that the opening of the horn faces left-side and right-side. The part numbers of the tweeter for L ch and R ch are different. Be careful in the tweeter installation. The opening of the horn face becomes the reverse direction when it attaches a tweeter for L ch and R ch in reverse.
1.2 WOOFER
� Each woofer is attached to the cabinet with 4 screws accessible from the outside. To remove the woofer, remove these screws. To reassemble, make sure that the terminal plate of the speaker unit faces to the lower .
1.3 TWEETER
1. Remove the upper woofer. 2. Remove the packing (SEC2186) between the upper woofer and the tweeter. Note: As packing cannot be reused, procure new packing (SEC2186) for reassembly. 3. Remove the 3 screws. Then pass your hand through the hole for the woofer and pull out the reinforcing plate.
1. The Network Assy for the tweeter is located at the upper of upper woofer, and the Network Assy for the woofer is located at the lower of the lower woofer. 2. As the screws are covered by packing, before removing the Network Assy remove the packing first, then remove the woofer. As packing cannot be reused, procure new packing (SEC2186) for reassembly. 3. Each Network Assy is attached to the inside of the cabinet with 4 screws accessible from the outside. 4. Pass your hand through the hole for the woofer and securely hold the Network Assy in place while removing the 4 screws. Pull the Network Assy out through the hole for the woofer.
1.4 NETWORK ASSY
PIONEER CORPORATION
4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2007
T-ZZR NOV. 2007 Printed in Japan
|
|
|
> |
|
