|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
Alignment & Adjustment
2-4 Other Adjustments
2-4-1 Screen Adjustment
1. Warm up the TV for at least 30 minutes. 2. Select the "STANDARD" Video Mode. 3. Turn to the Video Mode (No Signal) using a remote-control. 4. Connect an oscilloscope to RK,GK,BK. 5. Adjust the VR Screen (in the Focus Pack) to have 20VP-P for the RK, GK and BK pulse. (Turn the R, G and B VR screen fully counterclockwise at each flyback line.) � Voltage adjustment connt be done using a normal multi-tester. For adjustment, use an oscilloscope. The voltage shown by the tester is false data because the AC peak to peak voltage is adjusted under DC conditions.
2-4-2 White Balance Adjustment
1. Select the "STANDARD" Video Mode. 2. Input 100% white pattern. 3. In the stand-by mode, press the remote-control keys in the following sequence:
4. Warm up the TV for at least 30 minutes. 5. Input a 10-step signal. 6. R-cut off, B-cut off, and G-cut off by pressing the keys.
7. Adjust the low light with viewing the dark side of the screen. 8. Select R-drive, G-drive, and B-drive by pressing the keys.
9. Adjust the high light with viewing the light side of the screen. 10. If necessary, redo screen adjustments and 6~9. 11. Press the Add key to exit.
2-12
Samsung Electronics
|
|
|
> |
|
