JVC SP-DWF31AT
Owner's Manual

ENGLISH

Operations
Front /= Rear /=

Power lamp !"

Turning On the Power�POWER
To turn on the power. Press the POWER switch to the ON position. � The power lamp lights in green.
!" POWER ON � !"#$%&"'

!"POWER

To cut of the power. Press the POWER switch to the OFF position. � The power lamp goes out. � This will disconnect the mains lead.

!" POWER OFF � !"#$%& � !"#$%

Operating the Unit Automatically According to the Incoming Signals�AUTO POWER ON/STANDBY
To activate AUTO POWER ON/STANDBY. Press the AUTO POWER ON/STANDBY switch to the [ position. � If no sound comes in for 5-10 minutes, the unit enters standby mode. The power lamp lights in red. � If the unit detects incoming signals, the unit starts operating. The power lamp lights in green. ] ON

!"#$%&'()* AUTO POWER ON/STANDBY
AUTO POWER ON/STANDBY AUTO POWER ON/STANDBY [ ] ON � 5 10 !"#$%&'()*+,-./012,345 !"#$%&"' � !"#$%&'( )*+,-./0123)456

To cancel AUTO POWER ON/STANDBY. Press out the AUTO POWER ON/STANDBY switch to set it to the [_] CANCEL position.

AUTO POWER ON/STANDBY AUTO POWER ON/STANDBY

=[_] CANCEL

AUTO POWER ON / STANDBY

AUTO POWER ON / STANDBY

CANCEL

ON

CANCEL

ON

���

When the volume level of the amplifier is so low or the incoming signals are so weak that this unit cannot detect sounds, Auto Power On/Standby may not work correctly.

!"#!$%&'()*+,-'./0123456!7,AUTO POWER ON/STANDBY !"#L !"#"$% !"

�5�