|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
SECTION 3 TEST MODE
BASE UNIT SECTION
MANUAL TEST MODE Set the Test Mode: 1. Set the DIAL MODE switch to �P� (pulse). 2. While pressing the HANDSET LOCATOR key, insert the AC adaptor (Reset start). 3. With the HANDSET LOCATOR key, still held down, switch the DIAL MODE switch �P� (pulse) n �T� (tone) n �P� (pulse). 4. When the HANDSET LOCATOR key is released, test mode starts. 5. Firstly, �0� will be dialled out at 10 pps. Then �1�, �4�, �8� and �#� will be sent out by DTMF. 6. Set to TX ON. Goes to external line state in 1 CH. Release the Test Mode: 1. Pull out the AC adaptor or turn off the power. MACHINE TEST MODE Set the Test Mode: 1. With one of the CH setting terminals in �H� input state, cause Reset of Power ON. Equipment enters machine test mode. 2. Setting of CH according to logic input with CH setting terminal. 3. ON/OFF of TX is according to the input logic of the DIAL MODE terminal. Release the Test Mode: 1. Pull out the AC adaptor or turn off the power. 2. Remove the short plug and turn on the power again.
� base main board (conductor side) �
TP46
TP47
IC101
TP66 TP62 TP63 TP61 TP65 TP67 TP64 IC501
TP106
7
|
|
|
> |
|
