|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exellent manual ,it was in great condition,and got all the info i expected,5 stars!!
;
I searched the Internet exhaustively for this manual and Owner-Manuals was the least expensive...but provided an excellent reproduction within 4 hours. Very satisified.
 ;
Rapid and precise delivery. Good print. On the spot.
;
available for me the service manual is in order!
thanks
;
This is exactly the thing you need to service this box. The manual is complete and the quality of the scan is good. I recommend this!
HANDSET SECTION
MANUAL TEST MODE Set the Test Mode: 1. Enter the test mode by pressing key while pressing 1 and TALK keys when in idle condition. (Key operation n 1 n TALK ) 2. The RINGER will ring for 1 sec when the test mode is started. 3. Measurement mode of consumption current. (ch=01 state) 4. Use key input to carry out the various settings. 5. Use port inputs to set output from LED terminals. Release the Test Mode: 1. Press the OFF key. 2. Turn off the power. (Remove the battery and replace them.)
MACHINE TEST MODE Set the Test Mode: 1. When power on reset is applied while a �L� (low) is input the TEST I/O (TP316) terminal (IC401 #§ pin), the RING (Level H, 1 sec) sounds. 2. Checking the CH No. displayed on the LCD, up or down the JOG dial and select the No. It can be set by pushing the JOG dial. (�?� appears at the suffix No. is determined.) 3. Set the TX setting to TX OFF. 4. The channel is set by voice not by data. 5. Use port inputs to set output from LED terminals. Release the Test Mode: 1. Press the OFF key. 2. Remove the short plug and turn on the power.
� hand key board (side B) � TP314 TP316
TP201
IC401 TP209 TP206
TP207 TP208 TP204 TP202
TP203
� 14 �
TP205
|
|
|
> |
|
