|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
 ;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
 ;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
 ;
thanks you are the best.Very good detail, Quick service response. A useful service manual with all details.
SECTION 3 TEST MODE
BASE UNIT
1. How to enter the test mode 1-1. Manual test mode Set the [DIAL MODE] switch to �P� (Pulse). While pressing the [PAGE] key, switch on the power supply. (Reset start) With the [PAGE] key still held down, switch the [DIAL MODE] switch �P� (Pulse)n�T� (Tone)n�P� (Pulse). When you release the [PAGE] key, test mode starts. If you release the [PAGE] key during this process, the machine operates in normal mode. <How to Release the Test Mode> � Pull out the AC adapter and turn off the power. 1-2. Machine test mode Set the [DIAL MODE] switch to �P� (Pulse). If you switch on the power with the TEST I/O port (IC501 !� pin) set to high (connect TP7 to TP608), the machine enters test mode.
[BASE MAIN BOARD] (Component Side)
21 20 TP7
22
25
TEST MODE terminal
15 TP608 IC501 35 30
( Short ::Test mode ) Open Normal
10
5 40 1 42
<How to Release the Test Mode> 1) Pull out the AC adapter and turn off the power. 2) Remove the short plug and turn on the power again.
� 11 �
 $4.99 SPPM100 SONY Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
 |
> |
|